Hey there! I’m excited to share this easy centerpiece that I put together this weekend!
Here’s how I made it 🙂
I made all of my cuts first. You can make it as big or as small as you like, this is just the size that I wanted for my Dining Table.
4- 2×3 pieces @ 32″
4 – 2×3 pieces @ 7 1/4″
4 – 2×3 pieces @ 5″
4 – 1×3 pieces @ 32″
Next, I drilled one 1 1/2″ pocket hole into each end of the 5″ pieces, with my Kreg Jig.
and attached them to the 32″ 2×3 pieces with 2″ pocket hole screws.
Now, this is where the steps get a little different than usual! I finished all of the pieces, at this point, before assembling the rest of the crate.
While I waited for the paint to dry, I began cutting the metal sheets. I purchased two sheets at Hobby Lobby for about $7 each (when they were marked at 40% off)! They have lots of different patterns to choose from!
After I attached the metal to the long sides, I assembled the crate by attaching each frame to the 7 1/4″ pieces. I used Elmer’s ProBond and 2″ nails with in Ryobi Airstrike Nailer to attach the pieces. Once the crate is assembled, you can add the metal to the short ends with the stapler.
Remember the stain and paint I applied? I went back with my Corner Cat Sander and distressed the entire crate with an 80-grit pad. This will allow the stain and bare wood to peek through the paint, giving our crate that awesome vintage look 🙂
I added a pull on each end, filled it with 7 empty wine bottles and dropped a pretty flower in each one 🙂
If you missed my new Restoration Hardware Inspired Dining Table, you can check it out HERE!
Thanks so much for stopping by 🙂