Hey there!!! I am so excited to show you what I have been working on. It is GORGEOUS!!!
Meet the newest addition to my dining room – a DIY Turned Leg Buffet Table! I’m in LOVE! This is a 6 foot buffet table with a TON of storage space and although it is large, it was a very easy build! I got the legs from Osborne Wood Products and they are definitely the focal point of this piece! You can purchase the legs HERE (I used 4 knotty pine).
Total cost for this piece was about $350 – not bad for a 6 foot buffet table! I did have some scrap left over that I will be able to use on future projects too!
As always, we have the FREE Printable Plans and a step-by-step tutorial for you! Click HERE or the image below to print the plans.
I started by gluing the 2 legs together with Gorilla Wood Glue. You can purchase the legs HERE!
While the glue was drying, I attached the back panel to the back legs. I used Purebond Plywood, in birch, for this project!
Next, I used my Ryobi 18V Jig saw to cut notches in the shelves. (I purchased another sheet of 3/4″ Purebond for the shelves but you can also use a project panel if they have one at your hardware store).
I used my Kreg R3 to drill pocket holes on the back of the shelves. The R3 is a great option for your first Kreg Jig tool. I still use mine on large pieces like this!
And built the drawers to fit my measurements. I like to use my Kreg right angle clamp to hold pieces while I attach them!
The final step on the drawers is to sand them down so that they slide easily. I used my Ryobi Corner Cat with 50-grit to sand the edges.
I added a few goodies from Save On Crafts! This is a great online store with so many inexpensive and cute accessories! I ordered this Tiered Serving Tray, the Glass Bottles and the cute Dried Artichokes and they arrived at my house in about a week!
Thanks so much for stopping by!!!!